Merging cuts 5mm off in left side

camoca · Post by **camoca** » Wed Sep 06, 2006 5:17 pm

When using the merge function, approx 5mm is cut off in left side, when printing from a screen capture program.

This does not happen when merge is off.

Is there some kind off setting that controls this?

************************************************************

I found the solution by installing the "Ghostscript PDF" driver.
The port of the Ghostscript PDF driver shall be the "Bullzip PDF" printer.
Printing should be done to the "Ghostscript PDF" driver.

However when printing to PDF in landscape, the captured screen is aligned to the left side of the paper. Is there a way to adjust the left margin or center the print on the page?